Toyota Corolla (E120): Short in side squib (rh) circuit

Dtc b0110/43 short in side squib (rh) circuit

Share this page:

Other materials:

Inspection procedure
1 Check door lock 2 Check wire harness (tvip ecu door lock) Disconnect the tvip ecu and door lock connectors.  check the continuity between the terminals of the tvip ecu and door lock connectors, as shown in the illustration and table. Standard: 3 Check wire harness ...

Rear axle lh hub bolt
Replacement Hint: components: 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Remove rear axle lh hub bolt Using sst and a hammer handle or an equivalent, remove the lh hub bolt. Sst 09628–10011 4. Install rear axle lh hub bolt Install a washer and nut to a ...

Dtc check/clear
Notice: if there is no dtc in the normal mode, check the pending fault code using the continuous test results function (mode 7 for sae j1979) on the obd ii scan tool or the hand–held tester. Hand–held tester only: when the diagnosis system is switched from the normal mode to the ...