Toyota Corolla (E120): Short in p/t squib (lh) circuit (to ground)

Dtc b0137/71 short in p/t squib (lh) circuit (to ground)

Share this page:

Other materials:

Inspection procedure
1 Check wire harness(dlc3 – airbag sensor assy center) Turn the ignition switch to the lock position.  disconnect the aribag sensor assy center connector.  measure the resistance according to the value(s) in the table below. Standard: 2 Check wire harness(cg of dl ...

Adjustment
1. Put vehicle these conditions  tire inflation pressure is the specified value .  start the engine. 2. Adjust fog light aim The fog light aim can be adjusting by moving the aiming screw in the vertical direction. Hint: the optical aim moves upward when turning a scr ...

Speed sensor front lh
Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove front wheel 2. Remove front fender liner lh 3. Remove speed sensor front lh Disconnect the speed sensor wire harness clamp from the body.  disconnect the speed sensor connector. Remo ...