Toyota Corolla (E120): Short in d squib circuit

Dtc b0100/13 short in d squib circuit

Share this page:

Other materials:

Skid control sensor
Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire Disconnect the skid control sensor wire connector from the skid control sensor. 4. Remove rear axle hub & ...

Inspection procedure
Hint: hand–held tester only: narrowing down the trouble area is possible by performing ”a/f control” active test (heated oxygen sensor or other trouble areas can be distinguished). Perform active test using hand–held tester (a/f control). Hint: ”a/f control” is the active te ...

General information
There are many ecu controlled systems used in the corolla. In general, ecu controlled system are considered to be very intricate and require a high level of technical knowledge and expert skill to troubleshoot. The fact is, however, that if you proceed by inspecting the circuits one by one, ...