Toyota Corolla (E120): Shift solenoid ”b” control circuit low/high

Dtc p0976 shift solenoid ”b” control circuit low (shift solenoid valve s2)

Dtc p0977 shift solenoid ”b” control circuit high (shift solenoid valve s2)

Share this page:

Other materials:

Circuit description
Refer to dtc p0120 Dtc no. Dtc detection condition Trouble area P0121 The following condition is met 4 times. After the vehicle speed has exceeded 19 mph (30 km/h) once, the throttle position sensor output value is out of normal range when the throttle ...

Speed sensor front lh
Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove front wheel 2. Remove front fender liner lh 3. Remove speed sensor front lh Disconnect the speed sensor wire harness clamp from the body.  disconnect the speed sensor connector. Remo ...

Ecm (1zz–fe)
Replacement 1. Disconnect battery negative terminal 2. Remove glove compartment door assy 3. Remove ecm Remove the 2 clips using a clip remover. Then, open the cover. Disconnect the 4 ecm connectors.  remove the wire harness from the wire harness clamp. Remove the 2 ...