Toyota Corolla (E120): Sfr/Sfl/Srr/Srl solenoid circuit

Share this page:

Other materials:

Inspection procedure
1 Check relay (marking: starter cut) Inspect the relay continuity, as shown in the illustration and table. Standard: 2 Check tvip ecu Disconnect the tvip ecu connector.  turn the ignition switch position to the start.  measure the voltage between the termina ...

Removal & installation and disassembly & re
1. Remove bench type rear seat cushion assy (, 72–8) 2. Remove rear floor service hole cover 3. Work for preventing gasoline from spilling out  start the engine.  after the engine has stopped on the its own, turn the ignition switch to lock. 4. Disconnect fuel tank main tu ...

How to proceed with troubleshooting
The hand–held tester can be used at step 4, 6, 8 and 9. 1 Vehicle brought to workshop 2 Customer problem analysis 3 Warning light check 4 The dtcs check (present and past dtcs) 5 The dtcs chart 6 Circuit inspection 7 Repair 8 Clear the dtcs (present and past dtcs) 9 The dt ...