Toyota Corolla (E170): Setting the alarm system

Close the doors, trunk and hood, and lock all the doors. The system will be set automatically after 30 seconds.

The indicator light changes from being on to flashing when the system is set.

Deactivating or stopping the alarm

    Share this page:

    Other materials:

    Floor shift cable transmission control select
    Replacement Hint: components: 1. Remove air conditioner unit assy Hint: refer to the instructions for removal of the air conditioner unit assy. 2. Separate air bag sensor assy center  remove the 3 bolts, separate the airbag sensor assy center. 3. Remove exhaust pipe assy 4. Remo ...

    Inspection procedure
    1 Check relay (marking: starter cut) Inspect the relay continuity, as shown in the illustration and table. Standard: 2 Check tvip ecu Disconnect the tvip ecu connector.  turn the ignition switch position to the start.  measure the voltage between the termina ...

    Replacement
    1. Disconnect battery negative terminal 2. Remove engine under cover rh 3. Remove starter assy Disconnect the starter connector.  open the terminal cover. remove the nut, then disconnect the starter wire.  remove the 2 bolts, then remove the starter. 4. Install starter a ...