Toyota Corolla (E170): Setting ringtone
1 Select “Ringtone” using
. 2 Using
, select a ringtone (1 - 3). To set
the selected ringtone, press
.
Other materials:
Inspection procedure
1 Inspect stop lamp switch assy
2 Check harness and connector(stop lamp switch assy – ecm)
Install the stop lamp switch assy.
disconnect the ecm connector.
measure the voltage according to the value(s) in the table
below when the brake pedal is depressed and rele ...
Fail–safe chart
If any of the following codes is recorded, the ecm enters the fail–safe mode.
Check for intermittent problems
Hand–held tester only:
by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is
possible instead of the
2 trip detection logic, and the sensitivity to de ...
Inspection procedure
1 Check hazard warning signal switch assy
Check the hazard warning switch continuity, as shown in
the illustration and table.
Standard:
2 Check turn signal flasher assy
3 Check wire harness (tvip ecu turn signal flasher)
Disconnect the tvip ecu and turn signal flashe ...


