Toyota Corolla (E170): Setting call volume

1 Select “Call volume” using Change the call volume.. 2 Change the call volume.

To decrease the volume: Turn To increase the volume: Turn  clockwise. counterclockwise.

To increase the volume: Turn Setting ringtone volume clockwise.

    Share this page:

    Other materials:

    Oxygen sensor monitor (front and rear o2s system)
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

    Emergency flashers
    The emergency flashers are used to warn other drivers when the vehicle has to be stopped in the road due to a breakdown, etc. Press the switch. All the turn signal lights will flash. To turn them off, press the switch once again. ■Emergency flashers If the emergency flashers are used ...

    Outside vehicle
    General maintenance Performing these maintenance checks on the vehicle in the owner’s responsibility. The owner may perform the maintenance or take the vehicle to a service center. Check the parts of the vehicle described below on a daily basis. In most cases, special tool are not requir ...