Toyota Corolla (E170): Setting automatic connection of the device on or off

If “BT power” is set to on, the registered device will be connected automatically when the engine switch is turned to the “ACC” position (vehicles without a smart key system) or ACCESSORY mode (vehicles with a smart key system).

1 Select “BT Power” using 2 Select “ON” or “OFF” using .. 2 Select “ON” or “OFF” using Displaying the device status.

    Share this page:

    Other materials:

    For safe driving
    For safe driving, adjust the seat and mirror to an appropriate position before driving. Correct driving posture Adjust the angle of the seatback so that you are sitting straight up and so that you do not have to lean forward to steer. Adjust the seat so that you can depress the pedals fully ...

    Replacement
    Hint: components: 1. Precaution 2. Disconnect battery negative terminal 3. Remove seat track upper rail cover rh 4. Remove seat track upper rail cover lh 5. Remove front seat assy lh 6. Remove seat position air bag sensor Disconnect the connector of the seat position airbag sensor. ...

    Overhaul
    1. Remove cylinder block water drain cock sub–assy Remove the cylinder block water drain cock from the cylinder block. 2. Inspect connecting rod thrust clearance Using a dial indicator, measure the thrust clearance while moving the connecting rod back and forth. Standard t ...