Toyota Corolla (E120) 2002–2008 Repair Manual / Service specifications
Toyota Corolla (E120): Service specifications
- Standard bolt
- Engine control system
- Fuel
- Engine mechanical
- Exhaust
- Cooling
- Lubrication
- Ignition
- Starting & charging
- Front suspension
- Rear suspension
- Brake
- Automatic transmission / transaxle
- Manual transmission / transaxle
- Clutch
- Steering column
- Heater & air conditioner
- Sliding roof/convertible
Other materials:
Changing engine switch
modes
Modes can be changed by
pressing the engine switch with
brake pedal released. (The
mode changes each time the
switch is pressed.)
OFF*1
The emergency flashers can be
used.
ACC*2
Some electrical components such
as the audio system can be used.
"ACCESSORY" will be displayed
on the multi-info ...
Inspection procedure
1 Inspect dlc3 terminal voltage(tc terminal)
Turn the ignition switch to on.
measure voltage between terminals tc and cg of dlc3.
Ok:
voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
Check for open and short circuit in harness and connector betw ...
Removal & installation and disassembly & reassembly
1. Remove bench type rear seat cushion assy
2. Remove rear floor service hole cover
Remove the rear service hole cover.
Disconnect the fuel pump and vapor pressure sensor
connector.
3. Work for preventing gasoline from spilling out
Start the engine.
after the engi ...


