Toyota Corolla (E170): Selecting the audio source

Switching between audio sources such as radio and CD are explained in this section.

Share this page:

Other materials:

Seat belt warning lamp for front passenger’s seat does not flash
Wiring diagram Inspection procedure 1 Inspect combination meter assy Ground terminal c9–11 on the combination meter side.  check that the warning lightlights up. Ok: warning light lights up. 2 Inspect passenger seat belt warning lamp assy Ground terminal c9– ...

Evap monitor (vacuum pressure monitor)
Notice: a cold soak must be performed prior to conducting the drive pattern to complete the internal pressure readiness monitor. Cold soak preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less. ...

Inspection procedure
1 Check side air bag sensor assy rh Sst 09843–18040 Connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.  turn the ignition switch to on, and wait at least for 20 seconds.  clear the dtc stored in memory .  turn the ignition swi ...