Toyota Corolla (E120): Seat belt warning system

Share this page:

Other materials:

Removal & installation and disassembly & re
1. Remove bench type rear seat cushion assy (, 72–8) 2. Remove rear floor service hole cover 3. Work for preventing gasoline from spilling out  start the engine.  after the engine has stopped on the its own, turn the ignition switch to lock. 4. Disconnect fuel tank main tu ...

Circuit description
A flat type knock sensor (non–resonant type) has the structure that can detect the vibration in a wider band of frequency from about 6 khz to 15 khz and has the following features. Knock sensors are fitted on the cylinder block to detect the engine knocking. The sensor contains a piezoele ...

Inspection procedure
1 Input signal check See input signal check on page 05–745. check the indicator light operation when each of the set/ coast, resume/accel and cancel is turned on. Ok: set/coast, resume/accel switch: the signals shown in the table on the left should be output when each switch is ...