Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Combination meter / Seat belt warning lamp for driver’s seat does not
operate
Toyota Corolla (E120): Seat belt warning lamp for driver’s seat does not operate
Wiring diagram
Inspection procedure
1 Check combination meter assy
- Ground terminal c9–12 on the combination meter side.
- check that the warning lightlights up.
Ok: warning light lights up.
2 Inspect front seat inner belt assy lh
- Disconnect the front seat inner belt assy.
- check continuity front seat inner belt assy.
Repair or replace harness or connector
Other materials:
Follow the correction procedures. (vehicles with a smart key system and with
a drive monitor display)
After taking the specified steps to correct the suspected problem, check that
the warning light turns off.
■SRS warning light
This warning light system monitors the airbag sensor assembly, front impact
sensors, side impact sensors (front door), side impact sensors (front), side impac ...
Overhaul
1. Inspect 1st gear thrust clearance
Using a feeler gauge, measure the 1st gear thrust clearance.
Standard clearance:
0.10 – 0.40 Mm (0.0039 – 0.0157 In.)
2. Inspect 2nd gear thrust clearance
Using a dial indicator, measure the 2nd gear thrust clearance.
Standard clearan ...
Disposal
Hint:
when scrapping vehicle equipped with an srs or disposing of a instrument panel
passenger airbag assy,
always first deploy the airbag in accordance with the procedure described below.
If any abnormality occurs
with the airbag deployment, contact the service dept. Of toyota motor sales,
...