Toyota Corolla (E120): Seat belt

Share this page:

Other materials:

Inspection
1. Inspect driver’s door lock Inspect the door lock motor operation. Standard: If the result is not as specified, replace the door lock assembly. Inspect the door lock and unlock switch continuity. Standard: If the result is not as specified, replace the door lock assem ...

Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector between ...

Deactivating or stopping the alarm
Do one of the following to deactivate or stop the alarm: ● Unlock the doors or open the trunk. ● Vehicles without a smart key system: Turn the engine switch to the “ACC” or “ON” position, or start the engine. (The alarm will be deactivated or stopped after a few seconds.) & ...