Toyota Corolla (E170): Scanning files

1 Press The first 10 seconds of all files in the folder will be played..

The first 10 seconds of all files in the folder will be played.

2 When the desired folder is reached, pressagain. again.

    Share this page:

    Other materials:

    For vehicles equipped with mobile communication system
    Install an antenna as far as possible away from the ecu and sensors of the vehicle’s electronic systems.  install an antenna feeder at least 20 cm (7.87 In.) Away from the ecu and sensors of the vehicle’s electronic systems. For details of the ecu and sensors locations, refer ...

    Inspection procedure
    1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...

    Inspection procedure
    Hint: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using the hand–held tester. 1 Read value of hand–held tester(skid control sensor) Check that there is no difference between the speed value output from the speed sensor ...