Toyota Corolla (E120): Replacement

Hint

: installation is in the reverse order of the removal. But the installation is indicated only when it has a point.

1. Remove radiator grille sub–assy

  1. Remove the 2 bolts and clip.
  2.  using a screwdriver, remove the radiator grille.

Hint

: tape the screwdriver tip before use.

2. Remove front bumper cover

  1. Remove the 6 screws and 2 clips.
  2.  disengage the hook, and remove the front bumper cover.
  3.  w/ fog light: disconnect the fog light connectors.

3. Remove front bumper energy absorber

4. Remove front bumper reinforcement

  1. Disconnect the wire harness clamp.
  2.  remove the 4 nuts and front bumper reinforcement.

5. Remove front bumper side mounting bracket lh

6. Remove front bumper side mounting bracket rh

7. Remove front lh spoiler sub–assy (w/ front spoiler)

  1.  remove the screw and 4 retainers.
  2.  disengage the clip and front lh spoiler.
  3.  employ the same manner described above to the other side.

8. Remove front rh spoiler sub–assy (w/ front spoiler)

9. Remove fog light unit lh (w/ fog light)

  1.  remove the nut and fog light unit.
  2.  employ the same manner described above to the other side.

10. Remove fog light unit rh (w/ fog light)

11. Remove front bumper hole cover lh (w/o fog light)

12. Remove front bumper hole cover rh (w/o fog light)

13. Install front bumper reinforcement

  1. Install the front bumper reinforcement with the 4 nuts.

    Torque: 36 nvm (367 kgfvcm, 27 ftvlbf)

14. Install radiator grille sub–assy

  1. Install the radiator grille with the 2 bolts and clip.

    Torque: 5.0 Nvm (51 kgfvcm, 44 in.Vlbf)

    Share this page:

    Other materials:

    Malfunction in tachometer
    Wiring diagram Inspection procedure Check output value of ecm.  Connect the hand–held tester to dlc3. Turn the ignition switch to on and push the hand–held tester main switch on.  Select the data list mode on the hand–held tester. 2 Inspect combinatio ...

    Front seat airbag assy rh
    Disposal Hint: when scrapping vehicles equipped with an srs or disposing of the front seat airbag assy always first deploy the airbag in accordance with the procedure described below. If any abnormality occurs with the airbag deployment, contact the service dept. Of toyota motor sales ...

    Engine coolant
    The coolant level is satisfactory if it is between the “F” and “L” lines on the reservoir when the engine is cold. 1 Reservoir cap 2 “F” line 3 “L” line If the level is on or below the “L” line, add coolant up to the “F” line. ■Coolant selection Only use “To ...