Toyota Corolla (E120): Replacement

Hint

: components:

1. Precaution

2. Disconnect battery negative terminal

3. Remove air bag front rh sensor

  1. Disconnect the connector from the airbag front rh sensor.
  2.  remove the 2 bolts and airbag front rh sensor.

4. Inspect air bag front rh sensor

5. Install air bag front rh sensor

  1.  check that the ignition switch is turned to off.
  2.  check that the battery negative terminal is disconnected.

    Notice

    : do not start the operation for 90 seconds after removing the terminal.

  3.  install the airbag front rh sensor with the 2 bolts.

    Torque: 8.0 Nvm (82 kgfvcm, 71 invlbf)

  4.  connect the connector to the airbag front rh sensor.
  5.  check that no play is identified.

6. Inspect srs warning light

    Share this page:

    Other materials:

    How to check and change detailed Bluetooth® settings
    1 Display the “Bluetooth* Setup” screen. 2 Select “System Settings”. 3 The following screen is displayed: 1 Bluetooth® Power on/off You can change Bluetooth® function on/off 2 Bluetooth® Name 3 Change PIN-code 4 Bluetooth® Address 5 Display Phone Status You can set the system ...

    Steering wheel audio switches
    Some audio features can be controlled using the switches on the steering wheel. Operation may differ depending on the type of multimedia system or navigation system. For details, refer to the manual provided with the multimedia system or navigation system. Operating the multimedia system using ...

    Inspection procedure
    1 Check voltage at ig2 of airbag sensor assy center Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connector of the airbag sensor assy center.  connect the negative (–) terminal cable to the battery, and wa ...