Toyota Corolla (E120): Replacement

1. Discharge refrigerant from refrigeration system

  1.  turn the a/c switch on.
  2.  operating the cooler compressor at the engine rpm of approx. 1000 For 5 to 6 min., Circulate the refrigerant and collect compressor oil remaining in each component into the cooler compressor as much as possible.
  3.  stop the engine.
  4.  let the refrigerant gas out.

    Sst 07110–58060 (07117–58080, 07117–58090, 07117–78050, 07117–88060, 07117–88070, 07117–88080)

2. Charge refrigerant

  1.  using a vacuum pump, perform a vacuum pumping.
  2.  supply refrigerant, hfc–134a (r134a).

    Standard: 490 30 g (17.28 1.06 Oz.) Sst 07110–58060 (07117–58060, 07117–58070, 07117–58080, 07117–58090, 07117–78050, 07117–88060, 07117–88070, 07117–88080), 07117–48130, 07117–48140

3. Warm up engine

4. Inspect leakage of refrigerant

  1.  using a gas leak detector, check for leakage of refrigerant.
    Share this page:

    Other materials:

    Vehicle control system
    Ignition or starter switch assy Replacement 1. Remove steering column cover 2. Remove ignition or starter switch assy Disconnect the ignition switch connector and unlock warning switch connector.  remove the 2 clamps.  remove the 2 screws and ignition switch. Inspectio ...

    Speaking on the phone
    The following screen is displayed when speaking on the phone. To adjust the call volume Select “-” or “+”. You can also adjust the volume using the steering switches or the volume knob. To prevent the other party from hearing your voice Select “Mute”. Inputting tones When using ...

    Inspection procedure
    1 Check harness and connector(transmission control switch – body ground) Disconnect the transmission control switch connector of shift lever assy. measure the resistance according to the value(s) in the table below. Standard: 2 Inspect transmission control switch M ...