Toyota Corolla (E120): Replacement

1. Remove clutch start switch assy

  1.  disconnect the clutch start switch assy connector.
  2.  remove the nut and clutch start switch assy from the clutch pedal support.

2. Install clutch start switch assy

  1.  install the clutch start switch assy with the nut.

    Torque: 15.68 Nvm (160 Kgf·cm, 12 ft·lbf)

  2.  connect the clutch start switch assy connector.

3. Inspect clutch start switch assy

    Share this page:

    Other materials:

    Inspection procedure
    1 Check side squib(lh) circuit(airbag sensor assy center – front seat airbag assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...

    Electronic control
    Removal and installation of battery terminal  before performing electrical work, disconnect the battery negative (–) terminal cable beforehand so as to prevent burnt–out damage by short.  When disconnecting and installing the terminal cable, turn the ignition switch an ...

    LTA (Lane Tracing Assist)
    LTA functions When driving on a road with clear lane lines with the dynamic radar cruise control operating, lane lines and preceding and surrounding vehicles are detected using the front camera and radar sensor, and the steering wheel is operated to maintain the vehicle's lane position. ...