Toyota Corolla (E120): Replacement
1. Remove battery
2. Remove battery carrier
- Remove the 4 bolts and battery carrier.
3. Disconnect floor shift cable transmission control shift
- Remove the nut from the control shaft lever.
- disconnect the control cable from the control shaft lever.
- remove the clip and disconnect the control cable from the control cable bracket.
4. Remove park/neutral position switch assy
- Disconnect the park/neutral position switch connector.
- remove the nut, washer and control shaft lever.
- pry out the lock plate and remove the manual valve shaft nut.
- remove the 2 bolts and pull out the park/neutral position switch.
5. Install park/neutral position switch assy
- Install the park/neutral position switch to the manual valve shaft.
- temporarily install the 2 bolts.
- place a new lock plate and tighten the nut.
Torque: 5.5 Nvm (56 Kgf·cm, 49 in.Vlbf)
- temporarily install the control shaft lever.
- Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.
- remove the control shaft lever.
- Align the groove with neutral basic line.
- hold the switch in position and tighten the 2 bolts.
Torque: 5.5 Nvm (56 Kgf·cm, 49 in.Vlbf)
- Using a screwdriver, stake the nut with the lock plate.
- Install the control shaft lever, washer and nut.
Torque: 12.5 Nvm (127 Kgf·cm, 9 ft·lbf)
- connect the park/neutral position switch connector.
6. Install floor shift cable transmission control shift
- Temporarily install the control cable to the control shaft lever with nut.
- install the control cable and clip to the bracket.
7. Install battery carrier
- Install the battery carrier and 4 bolts.
Torque: 13 nvm (132 Kgf·cm, 10 ft·lbf)
8. Adjust shift lever position
9. Inspect shift lever position
10. Inspect park/neutral position switch assy
Other materials:
Cd cannot be inserted or is ejected right after
insertion
Wiring diagram
Inspection procedure
1 Check if a proper cd is inserted
Check that a proper cd is inserted.
Make sure that the cd is normal audio cd, and that there is no
deformation, flaw, stain, burr and
other defects on the cd.
Standard: normal audio cd.
Reference:
...
Cassette tape cannot be ejected
Wiring diagram
Wiring diagram
1 Check if radio auto–search functions properly
Check if the radio auto–search function properly.
Perform the auto–research of the radio and check that the
operation is normal.
Standard: malfunction disappear.
2 Press ”eject” and ...
Terminals of ecu
Oscilloscope wave (*1)
Hint:
terminal: od – gnd
gauge set: 5 v / div, 50 ms / div
condition: during cruise control driving o/d switch on.
...