Toyota Corolla (E120): Replacement

1. Remove console box sub–assy rear

2. Remove parking brake lever sub–assy

  1. Disconnect the parking brake switch connector from the parking brake switch.
  2.  remove the lock nut and adjusting nut from the parking brake cable assy no.1.

  1. Remove the 2 bolts.

  1. Using a screwdriver, raise the pick on the parking brake lever, and remove the parking brake cable assy no.1 From the parking brake lever.
  2.  remove the parking brake lever from the body.

3. Remove parking brake switch assy

  1. Remove the screw and parking brake switch assy.

4. Install parking brake switch assy

  1. Install the parking brake switch to the parking brake lever sub–assy with the screw.

5. Install parking brake lever sub–assy

  1. Install the parking brake cable assy no.1 To the parking brake lever, temporarily tighten the adjusting nut and lock nut.
  2.  using a screwdriver, fix the parking brake cable no.1 To the pick.

  1. Install the parking brake lever with the 2 bolts.

    Torque: 12.5 Nvm (130 Kgf·cm, 9 ft·lbf)

  1. Connect the parking brake switch connector to the parking brake switch.

6. Inspect parking brake lever travel

7. Adjust parking brake lever travel

8. Install console box sub–assy rear

    Share this page:

    Other materials:

    Valve clearance
    Adjustment 1. Remove cylinder head cover no.2 Remove the 2 nuts, 2 clips and cylinder head cover. 2. Disconnect engine wire Remove the 5 clamps from the 5 clamp brackets. Disconnect the 4 ignition coil connectors. Remove the bolt and nut installing the engine wire ...

    What to do if... (Troubleshooting)
    If you have a problem, check the following before contacting your Toyota dealer. The doors cannot be locked, unlocked, opened or closed You lose your keys ● If you lose your keys or mechanical keys, new genuine keys or mechanical keys can be made by your Toyota dealer. ● If you lo ...

    Inspection procedure
    1 Check side squib(rh) circuit(airbag sensor assy center – front seat airbag assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...