Toyota Corolla (E120): Replacement
Hint
: components:
1. Remove rear wheel
2. Remove rear brake drum sub–assy
3. Disconnect skid control sensor wire (w/ abs)
4. Remove rear axle hub & bearing assy lh
- Remove the 4 bolts and hub & bearing assy lh.
5. Install rear axle hub & bearing assy lh
- Install the hub & bearing assy lh with the 4 bolts.
Torque: 61 nvm (622 Kgf·cm, 45 ft·lbf)
6. Connect skid control sensor wire (w/ abs)
7. Inspect bearing backlash
- Set a dial indicator near the center of the axle hub and
check the backlash in the bearing shaft sirection.
Maximum: 0.05 Mm (0.0020 In.)
If the backlash exceeds the maximum, replace the rear axle hub & bearing assy lh.
8. Inspect axle hub deviatio
- Using a dial indicator, check the deviation at the surface
of the axle hub outside the hub bolt.
Maximum: 0.07 Mm (0.0028 In.)
If the backlash exceeds the maximum, replace the rear axle hub & bearing assy lh.
9. Install rear brake drum sub–assy
10. Install rear wheel
torque: 103 nvm (1,050 Kgf·cm, 76 ft·lbf)
11. Check abs speed sensor signal (w/ abs)
Other materials:
Parking the vehicle
► Automatic transmission or continuously
variable transmission Automatic transmission or continuously variable transmission
1 With the shift lever in D, depress the brake pedal.
2 Shift the shift lever to P.
3 Set the parking brake.
4 Vehicles without a smart key system: Turn ...
Circuit description
The shift solenoid valve sl is turned ”on” and ”off” by signals from the ecm
in order to control the hydraulic
pressure operation, the lock–up relay valve, which then the controls operation
of the lock–up clutch.
Fail safe function:
if the ecm detects a malfunction, it turns the ...
Transmission wire (atm)
Replacement
1. Remove transmission valve body assy
2. Remove transmission wire
Disconnect the transmission wire connector.
removal the bolt and transmission wire.
3. Install transmission wire
Coat a o–ring with atf.
install the transmission wire and bolt.
To ...