Toyota Corolla (E120): Replacement
1. Remove engine under cover rh
2. Remove fan and generator v belt
3. Remove generator assy
- Disconnect the wire clamp from the wire clip on the rectifire end frame.
- remove the rubber cap and nut, and disconnect the alternator wire.
- disconnect the alternator connector.
- Remove the 2 bolts and alternator.
4. Install generator assy
Torque:
12 mm head 25 nvm (250 Kgf·cm, 18 ft·lbf)
14 mm head 54 nvm (550 Kgf·cm, 39 ft·lbf)
Other materials:
Replacement
1. Remove combination meter assembly
2. Disconnect brake master cylinder push rod clevis
remove the clip and push rod clevis pin and wave washer, and
disconnect the push rod clevis from
the brake pedal.
3. Remove brake pedal support sub–assy
Remove the bolt from the bra ...
Chassis
On–vehicle inspection
1. Inspect steering linkage
check the steering wheel freeplay .
check the steering linkage for looseness or damage.
Check that the tie rod ends do not have excessive play.
Check that the dust seals and boots are not damaged.
Chec ...
Body
On–vehicle inspection
1. Canada:
tighten bolts and nuts on chassis and body
tighten the bolts and nuts on the chassis parts listed below, if
necessary
Front axle and suspension
drive train
rear axle and suspension
brake system
engine mounting
other chassis parts
...