1. Remove engine under cover rh
2. Drain coolant
3. Remove fan and generator v belt
4. Remove generator assy
5. Remove water pump assy
6. Install water pump assy
Torque:
bolt a 9.0 Nvm (92 Kgf·cm, 80 invlbf)
bolt b 11 nvm (113 Kgf·cm, 8 ft·lbf)
7. Install generator assy
Torque:
12 mm head 25 nvm (250 Kgf·cm, 18 ft·lbf)
14 mm head 54 nvm (550 Kgf·cm, 39 ft·lbf)
8. Add coolant
9. Check engine coolant leak
Brake fluid
Bleeding
Notice:
wash the brake fluid off immediately if it comes into contact with any painted
surface.
Hint:
if any work is done on the brake system or if air in the brake lines is
suspected, bleed the air from the system.
1. Fill reservoir with brake fluid
fluid: sae j1703 or fmvss no. ...
General information
1. Basic dimensions
(a) there are two types of dimensions in the diagram.
(1) (Three-dimensional distance)
straight-line distance between the centers of two
measuring points.
(2) (Two-dimensional distance)
horizontal distance in forward/rearward direction
between the centers o ...
On–vehicle inspection
1. Inspect cooling system for leaks
Caution:
to avoid the danger of being burned, do not remove the radiator
cap while the engine and radiator are still hot, as fluid
and steam can be blown out under pressure.
fill the radiator with coolant and attach a radiator cap tester.
  ...