Toyota Corolla (E170) 2014–2019 Owners Manual / For safety and security / For safe use / Installing child restraints / Removing a child restraint installed with a seat belt
Toyota Corolla (E170): Removing a child restraint installed with a seat belt
Push the buckle release button and fully retract the seat belt.
Other materials:
Circuit description
The rear heated oxygen sensor is used to monitor oxygen concentration in the
exhaust gas. For optimum
catalytic converter operation, the air fuel mixture must be maintained near the
ideal ”stoichiometric” ratio.
The heated oxygen sensor output voltage changes suddenly in the vicinity of ...
Monitor description
While the engine is being cranked, the battery positive voltage is applied to
terminal sta of the ecm.
If the ecm detects the starter control signal (sta) while the vehicle is
driving, it will conclude that there is
a fault in the starter control circuit. The ecm will turn on the mil and a d ...
Oxygen / af sensor heater monitor
Preconditions
The monitor will not run unless:
mil is off
drive pattern
connect the obd ii scan tool to the dlc3 to check monitor status
and preconditions.
Start the engine and allow it to idle for 9 minutes.
Drive the vehicle at 25 mph (40 km ...