Toyota Corolla (E120) 2002–2008 Repair Manual / Introduction / Repair instruction / Precaution / Removal and installation of engine intake parts
Toyota Corolla (E120): Removal and installation of engine intake parts
- If any metal tip is mixed in the inlet pass, this may give a bad effect to the engine and turbocharger.
- when removing and installing the inlet system parts, close the opening of the removed inlet system parts and the engine with a clean shop rag or gummed tape.
- when installing the inlet system parts, check that there is no mixing of a metal tip.
Other materials:
Wiring diagram
1 Inspect terminal voltage(pi)
(a) turn
Turn the ignition switch to on.
measure voltage between terminal 5 (pi) of cruise control
ecu assy and body ground, when the cruise control main
switch button is on and off.
Ok:
2 Inspect combination meter assy
3 Check harn ...
Cassette tape cannot be inserted or played
Wiring diagram
Inspection procedure
1 Check for any foreign object
Check for any foreign object.
Check that no foreign object or defect is detected in the cassette
tape player of radio receiver
assembly.
Standard: no foreign object and defect detected.
2 Check cassett ...
Air outlets
■ Location of air outlets
The air outlets and air volume changes according to the selected airflow mode.
: Some models
■ Adjusting the position of and opening and closing the air outlets
► Front center outlets
Direct air flow to the left or right, up or down.
► Fron ...