Toyota Corolla (E170): Registering a new contact to the contact list

New contact data can be registered. Up to 4 numbers per person can be registered. For PBAP compatible Bluetooth® phones, this function is available when “Automatic Contact/History Transfer” is set to off.

1 Select “New Contact”.

2 Enter the name and select “OK”.

3 Enter the phone number and select “OK”.

4 Select the phone type for the phone number.

5 To add another number to this contact, select “Yes”.

■ Registering a new contact in a different way (From the “Call History” screen)

1 Display the phone screen. 2 Select the “Call History” tab and select a contact not yet registered in the contact list.

3 Select “Add to Contacts”.

4 Follow the steps in “Registering a new contact to the contacts list” from “STEP 3”.

    Share this page:

    Other materials:

    Front differential oil seal (atm)
    Replacement 1. Remove front wheels 2. Remove engine under cover rh 3. Remove engine under cover lh 4. Drain automatic transaxle fluid  remove the drain plug, gasket and drain atf.  install a new gasket and drain plug. Torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf) 5. Remove fron ...

    Inspection procedure
    1 Inspect dlc3 terminal voltage(tc terminal) Turn the ignition switch to on.  measure voltage between terminals tc and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector betw ...

    How to proceed with troubleshooting
    The hand–held tester can be used at step 4, 6, 8 and 9. 1 Vehicle brought to workshop 2 Customer problem analysis 3 Warning light check 4 The dtcs check (present and past dtcs) 5 The dtcs chart 6 Circuit inspection 7 Repair 8 Clear the dtcs (present and past dtcs) 9 The dt ...