Toyota Corolla (E120): Rear suspension

Preparation

Sst

Recomended tools

Recomended tools

Equipment

Equipment

Tire & wheel

Tire & wheel

Preparation

Equipment

Drive shaft / propeller shaft

    Share this page:

    Other materials:

    Evap monitor (vacuum pressure monitor)
    Notice: a cold soak must be performed prior to conducting the drive pattern to complete the internal pressure readiness monitor. Cold soak preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less. ...

    Inspection procedure
    1 Inspect transmission wire(sl) Disconnect the transmission wire connector from the transaxle.  measure the resistance according to the value(s) in the table below. Standard: 2 Check harness and connector(transmission wire – ecm) Connect the transmission wire c ...

    Malfunction in clock
    Wiring diagram Inspection procedure 1 Inspect fuse Check the continuity in cig fuse.  check the continuity in dome fuse. 2 Inspect harness or connector Check voltage.  Remove the clock assy with connector still connected.  Measure voltage between ter ...