Toyota Corolla (E120) 2002–2008 Repair Manual / Rear suspension
Toyota Corolla (E120): Rear suspension
- Rear suspension system
- Rear suspension
- Rear wheel alignment
- Rear shock absorber with coil spring
- Rear axle beam assy
- Stabilizer bar rear
Other materials:
Check and replace ecu
Notice:
start an inspection of the connector from the backside
of the connector on the wire harness side with
the connector connected to the ecu.
When no measurement condition is specified, perform
the inspection with the engine stopped and also
the ignition switch on.
First check the ec ...
Inspection procedure
1 Check d squib circuit(airbag sensor assy center – horn button
assy)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connector between the airbag sensor
assy center and the horn button assy.
for the black ...
Circuit description
Refer to dtc p0130
Dtc no.
Dtc detecting condition
Trouble area
P0134
After engine is warmed up, heated oxygen sensor (bank 1
sensor 1) output does not indicate rich (greater than 0.45 V)
even once when conditions (a), (b), (c), (d) and (e) continue for
...


