Toyota Corolla (E120) 2002–2008 Repair Manual / Rear suspension / Rear shock absorber with coil spring

Toyota Corolla (E120): Rear shock absorber with coil spring

Share this page:

Other materials:

Disposal
1. Dispose shock absorber assy rear lh Fully extend the shock absorber rod.  using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside. Caution: when drilling, chips may fly out, work carefully. The gas is colorless, odorless and no ...

Deactivating or stopping the alarm
Do one of the following to deactivate or stop the alarm: ● Unlock the doors or open the trunk. ● Vehicles without a smart key system: Turn the engine switch to the “ACC” or “ON” position, or start the engine. (The alarm will be deactivated or stopped after a few seconds.) & ...

Circuit description
The ignition switch provides circuit power and the ecm provides the circuit ground that illuminates the mil. Mil operation is checked visually: it should be illuminated when the ignition is first turned on. If the mil is off all of the time or on all of the time, use the procedure below to ...