Toyota Corolla (E120) 2002–2008 Repair Manual / Exterior/interior trim / Rear door belt moulding assy lh
Toyota Corolla (E120): Rear door belt moulding assy lh
Replacement
Hint
:
- the installation procedures are the removal procedures in reverse order.
- Use the same procedures for the rh side and lh side.
1. Remove rear armrest assy lh
2. Remove power window regulator switch assy rear (w/ power window)
3. Remove rear door window regulator handle assy (w/o power window)
4. Remove rear door trim board sub–assy lh
5. Remove rear door belt moulding assy lh
- Put protective tape under the weatherstrip.
- using a moulding remover, pry out the weatherstrip as shown in the illustration.
Hint
: tape the moulding remover tip before use.
Other materials:
Definition of terms
Term
Definition
Monitor description
Description of what the ecm monitors and how it detects malfunction
(monitoring purpose and its details).
Related dtcs
Diagnostic code
Typical enabling condition
Preconditions that allow the ecm to detect m ...
Warning lights
Warning lights inform the driver of malfunctions in the indicated vehicle’s systems.
*1: Vehicles without a smart key system:
These lights turn on when the engine switch is turned to the “ON” position to indicate
that a system check is being performed. They will turn off after the engi ...
Location of the spare tire, jack and tools
1 Luggage floor cover
2 Wheel nut wrench
3 Jack handle
4 Jack attachment*
5 Jack
6 Spare tire
7 Tool tray
*: The jack attachment is used when raising your vehicle with a floor jack.
CAUTION
■Using the tire jack
Observe the following precautions.
Improper use of the tire jack may c ...