Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Random/multiple cylinder misfire
detected
Toyota Corolla (E120): Random/multiple cylinder misfire detected
Dtc p0300 random/multiple cylinder misfire detected
Dtc p0301 cylinder 1 misfire detected
Dtc p0302 cylinder 2 misfire detected
Dtc p0303 cylinder 3 misfire detected
Dtc p0304 cylinder 4 misfire detected
Other materials:
Vehicle control system
Ignition or starter switch assy
Replacement
1. Remove steering column cover
2. Remove ignition or starter switch assy
Disconnect the ignition switch connector and unlock
warning switch connector.
remove the 2 clamps.
remove the 2 screws and ignition switch.
Inspectio ...
Disposal
1. Dispose shock absorber assy rear lh
Fully extend the shock absorber rod.
using a drill, make a hole in the cylinder as shown in the
illustration to discharge the gas inside.
Caution:
when drilling, chips may fly out, work carefully.
The gas is colorless, odorless and no ...
On–vehicle inspection
1. Inspect drive belt
Visually check the belt for excessive wear, frayed cords,
etc.
If any defect is found, replace the drive belt.
Hint:
cracks on the rib side of a belt are considered acceptable. If the
missing chunks from the ribs are found on the belt, it should be
replaced.
2 ...