Toyota Corolla (E120): Proportioning valve assy

Share this page:

Other materials:

On–vehicle inspection
1. Connect hand–held tester:  connect the hand–held tester to the dlc3.  start the engine and run it at idle.  select the active test mode on the hand–held tester. Hint: please refer to the hand–held tester operator’s manual for further details. 2. Inspect actua ...

Inspection procedure
1 Inspect dlc3 terminal voltage Turn the ignition switch to on.  measure voltage between terminals 13 (tc) and 4 (cg) of dlc3. Ok: voltage: 10 – 16 v 2 Check harness and connector(between cruise control ecu assy and dlc3) Check for open and short circuit in harness ...

Replacement
Hint: components: 1. Precaution 2. Disconnect battery negative terminal 3. Remove horn button assy Place the front wheels facing straight ahead.  using a torx socket wrench (t30), loosen the 2 torx screws until the groove along the screw circumference catches on the screw ca ...