Toyota Corolla (E120): Problem symptoms table

1. Wiper and washer system

On–vehicle inspection

    Share this page:

    Other materials:

    Check open circuit
    For the open circuit in the wire harness in fig. 1, Perform a resistance check in step (b) or a voltage check in step (c) to locate the section. Check the resistance.  Disconnect connectors a and c and measure the resistance between them. Resistance: 1 Ω or les ...

    Check mode procedure
    1. Dtc check (check mode) Hint: hand–held tester only: compared to the normal mode, the check mode has more sensing ability to detect malfunctions. Furthermore, the same diagnostic items which are detected in the normal mode can also be detected in the check mode. Procedure for check m ...

    Inspection procedure
    1 Check source voltage Measure the voltage of the battery. Ok: voltage: 10 – 14 v 2 Check air bag sensor assy center Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors from the airbag sensor assy ...