Toyota Corolla (E120) 2002–2008 Repair Manual / Preparation
Toyota Corolla (E120): Preparation
- Diagnostics
- Fuel
- Emission control
- Engine mechanical
- Cooling
- Lubrication
- Ignition
- Starting & charging
- Front suspension
- Rear suspension
- Drive shaft / propeller shaft
- Brake
- Parking brake
- Automatic transmission / trans
- Manual transmission/transaxle
- Clutch
- Steering column
- Power steering
- Heater & air conditioner
- Supplemental restraint system
- Seat belt
- Lighting
- Wiper & washer
- Audio & visual system
- Communication system
- Windshield/windowglass/mirror
- Instrument panel/meter
- Sliding roof/convertible
- Engine hood/door
- Exterior/interior trim
- Cruise control
Other materials:
Monitor description
The battery supplies electricity to the ecm even when the ignition switch is
off. This electricity allows the
ecm store data such as dtc history, freeze frame data, fuel trim values, and
other data. If the battery voltage
falls below a minimum level, the ecm will conclude that there is a fault ...
Inspection
1. Inspect sliding roof limit switch
Inspect the sliding roof limit switch continuity.
Standard:
If the continuity is not as specified, replace the switch.
2. Inspect sliding roof drive gear sub–assy
Connect the positive (+) lead from the battery to terminal
2 and the ne ...
Circuit description
The ecm compares the two waveforms of the heated oxygen sensors located
before and after the catalyst
to determine whether or not the catalyst performance has deteriorated.
Air–fuel ratio feedback compensation keeps the waveform of the heated oxygen
sensor in front of the catalyst
alterna ...