Toyota Corolla (E120): Precaution

1. Precaution of headlight bulb replacement

  1.  if even a thin film of oil is left on the surface of the halogen lamp, its service life will be shortened because the lamp will be burn at a higher temperature.
  2.  handle any halogen lamp with great care. Dropping, hitting or damaging the bulb, in any way, may result in it exploding and scattering because the internal pressure is high.
  3.  always prepare a new bulb for immediate replacement. While replacing the bulb, the lens may attract dust and moisture if removed from the vehicle for too long.
  4.  always use a bulb of the same wattage for replacement.
  5.  firmly reinstall the socket after bulb replacement. The lens may become cloudy or the light cavity may fill with water through the gaps around the socket.
    Share this page:

    Other materials:

    On–vehicle inspection
    1. Inspect front axle hub bearing  remove the front wheel.  separate the front disc brake caliper assy .  remove the front disc.  inspect the bearing backlash. Using a dial indicator, check the backlash near the center of the axle hub. Maximum: 0.05 Mm (0. ...

    Circuit description
    The camshaft position sensor (g22+ signal) consists of a magnet, iron core and pickup coil. The g22+ signal plate has 3 teeth on its outer circumference and is installed on the camshaft timing pulley. When the camshafts rotate, the protrusion on the signal plate and the air gap on the pi ...

    Inspection procedure
    1 Check d squib circuit(airbag sensor assy center – horn button assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the horn button assy. release the airbag ...