Toyota Corolla (E120): Precaution

1. Do not handle refrigerant in an enclosed area or near an open flame

2. Always wear eye protection

3. Be careful not to get liquid refrigerant in your eyes or on your skin

3. Be careful not to get liquid refrigerant in your eyes or on your skin

If liquid refrigerant gets in your eyes or on your skin.

If liquid refrigerant gets in your eyes or on your skin.

  1.  wash the area with lots of cool water.

    Caution

    : do not rub your eyes or skin.

  2.  apply clean petroleum jelly to the skin.
  3.  go immediately to a physician or hospital for professional treatment.

4. Never heat container or expose it to naked flame

5. Be careful not to drop container and not to apply physical shocks to it

6. Do not operate compressor without enough refrigerant in refrigerant system

If there is not enough refrigerant in the refrigerant system oil lubrication

If there is not enough refrigerant in the refrigerant system oil lubrication will be insufficient and compressor burnout may occur, so take care to avoid this, necessary care should be taken.

7. Do not open high pressure manifold valve while compressor is operating

If the high pressure valves opened, refrigerant flows in the reverse direction and could cause the charging cylinder to rupture, so open and close the only low pressure valve.

8. Be careful not to overcharge system with refrigerant

If refrigerant is overcharged, it causes problems such as insufficient cooling, poor fuel economy, engine overheating etc.

    Share this page:

    Other materials:

    Refueling
    Opening the fuel tank cap Perform the following steps to open the fuel tank cap: Before refueling the vehicle ● Close all the doors and windows, and turn the engine switch off. ● Confirm the type of fuel. ■Fuel types Unleaded gasoline (Octane rating 87 [Research Octane Number ...

    Inspection procedure
    1 Check courtesy lamp switch Check the courtesy switch, as shown in the illustration and table. Standard: 2 Check wire harness (integration relay  door courtesy sw) Disconnect the integration relay and door courtesy connectors.  check the continuity between th ...

    Antenna cord sub–assy
    Replacement Hint: components: 1. Remove instrument panel sub–assy upper Hint: refer to the procedure until the step, ”remove instrument panel sub–assy upper” of instrument panel sub–assy lower. Remove the related parts as long as the antenna cord sub–assy can be removed ...