Toyota Corolla (E120): Precaution
1. Handling precautions on srs airbag system
- The vehicle is equipped with srs (supplemental restraint system) such as the driver airbag and front passenger airbag. Failure to carry out service operation in correct sequence could cause the srs to unexpectedly deploy during servicing, possibly leading to a serious accident. Before servicing (including removal or installation of parts, inspection or replacement), be sure to read the precautionary notice for the supplemental restraint system
Other materials:
Inspection procedure
1 Check d squib circuit(airbag sensor assy center – horn button
assy)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the horn button assy.
release the airbag activ ...
On–vehicle inspection
1. Inspect air–fuel ratio compensation system
Hint:
you can also check the system by choosing ”data monitor”,
then ”o2 sensor output voltage” on the monitor of the
hand–held tester.
Connect the hand–held tester to the terminal 23 (ox1a)
@ 7 (e1) and 21 (ox1b) @ 7 (e1) of ...
Back up lamp assy lh
Replacement
1. Remove back up lamp assy lh
Remove the service hole cover.
remove the 2 nuts and disconnect the connector.
Using a mouldingremover, remove the 2 clips and back
up light assy lh.
2. Install back up lamp assy lh
Set the 2 clips on the back up ligh ...


