Toyota Corolla (E120): Precaution

  • Care must be taken to replace each part properly, because it could affect the performance of the brake system and result in a driving hazard. Replace the parts with the parts which have the same part number or equivalent.
  • It is very important to keep parts and the area clean when repairing the brake system.
  • If the vehicle is equipped with a mobile communication system, refer to the precaution in the introduction section.
    Share this page:

    Other materials:

    Source voltage drop
    The srs is equipped with a voltage–increase circuit (dc–dc converter) in the airbag sensor assy center in case the source voltage drops. When the battery voltage drops, the voltage–increase circuit (dc–dc converter) functions to increase the voltage of the srs to normal voltage. ...

    Checking and adding the brake fluid
    ■ Checking fluid level The brake fluid level should be between the "MAX" and "MIN" lines on the tank. ■ Adding fluid 1. Slide and lift up the rubber strip to partly remove it as shown. 2. Disconnect the claws and remove the service cover. 3. Remove the reservoir cap. 4. Add brake fluid slowl ...

    Inspection procedure
    1 Check wire harness(airbag sensor assy center – front seat inner belt assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat inner belt assy ( ...