Toyota Corolla (E120): Precaution

1. Check that the battery cables are connected to the correct terminals.

2. Disconnect the battery cables when the battery is given a quick charge.

3. Do not perform tests with a high voltage insulation resistance tester.

4. Never disconnect the battery while the engine is running.

5. Check that the charging cable is tightened on terminal b of the alternator and the fuse box.

6. Do not check whether the alternator generates or not with connecting terminal f to other terminal.

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...

    Fail–safe chart
    If any of the following codes is recorded, the ecm enters the fail–safe mode. Check for intermittent problems Hand–held tester only: by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is possible instead of the 2 trip detection logic, and the sensitivity to de ...

    Vehicle information
    This screen can be used to display the fuel consumption. “Trip Information” or “Past Record” screen Press “CAR” to display the “Trip Information” or “Past Record” screen. Fuel consumption ■ Trip information If the “Trip Information” screen does not appear, select â ...