Toyota Corolla (E170): Power windows
Other materials:
Valve clearance
Adjustment
1. Remove cylinder head cover no.2
Remove the 2 nuts, 2 clips and cylinder head cover.
2. Disconnect engine wire
Remove the 5 clamps from the 5 clamp brackets.
Disconnect the 4 ignition coil connectors.
Remove the bolt and nut installing the engine wire ...
Inspection procedure
1 Check relay (marking: starter cut)
Inspect the relay continuity, as shown in the illustration
and table.
Standard:
2 Check tvip ecu
Disconnect the tvip ecu connector.
turn the ignition switch position to the start.
measure the voltage between the termina ...
Circuit description
The camshaft position sensor (g22+ signal) consists of a magnet, iron core
and pickup coil.
The g22+ signal plate has 3 teeth on its outer circumference and is installed on
the camshaft timing pulley.
When the camshafts rotate, the protrusion on the signal plate and the air gap on
the pi ...