Toyota Corolla (E120) 2002–2008 Repair Manual / Power steering / Power steering system
Toyota Corolla (E120): Power steering system
Other materials:
Inspection procedure
Hand–held tester:
1 Perform active test by hand–held tester(operation of circuit
opening relay)
Connect the hand–held tester to the dlc3.
turn the ignition switch on and push the hand–held tester main
switch on.
select the item ”diagnosis / enhanced obd ii / active ...
Oxygen / af sensor heater monitor
Preconditions
The monitor will not run unless:
mil is off
drive pattern
connect the obd ii scan tool to the dlc3 to check monitor status
and preconditions.
Start the engine and allow it to idle for 9 minutes.
Drive the vehicle at 25 mph (40 km ...
Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal)
Turn the ignition switch to on.
measure voltage between terminals ts and cg of dlc3.
Ok:
voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
Check for open and short circuit in harness and connector between
...