Toyota Corolla (E170): Power outlet
Please use as a power supply for electronic goods that use less than 12 VDC/10 A (power consumption of 120 W).
Open the lid.
■The power outlet can be used when
► Vehicles without a smart key system The engine switch is in the “ACC” or “ON” position.
► Vehicles with a smart key system The engine switch is in ACCESSORY or IGNITION ON mode.
NOTICE
●To avoid damaging the power outlet, close the power outlet lid when the power outlet is not in use. Foreign objects or liquids that enter the power outlet may cause a short circuit.
●To prevent battery discharge, do not use the power outlet longer than necessary when the engine is off.
Other materials:
Circuit description
The side squib (lh) circuit consists of the airbag sensor assy center and
front seat airbag assy (lh).
It causes the srs to deploy when the srs deployment conditions are satisfied.
Dtc b0115/47 is recorded when a short is detected in the side squib (lh)
circuit.
Wiring diagram
...
Inspection procedure
1 Check harness and connector(transmission control switch –
body ground)
Disconnect the transmission control switch connector of
shift lever assy.
measure the resistance according to the value(s) in the
table below.
Standard:
2 Inspect transmission control switch
M ...
Inspection procedure
1 Check operation(stop lamp swtich assy)
Check that the stop light comes on when the brake pedal is depressed,
and turns off when the brake
pedal is released.
2 Input signal check
See input signal check on page 05–745.
check the indicator light when the brake pedal ...