Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Power door lock control system
Toyota Corolla (E120): Power door lock control system
|
Symptom |
Suspected area |
| All doors are not operated by driver’s door key cylinder interlocked with key |
|
| Key confinement prevention function does not work properly (unlock warning switch circuit) |
|
- How to proceed with troubleshooting
- Terminals of ecu
- All door lock and unlock do not operate by the master switch or the driver’s door key
- Key confinement prevention function does not work properly (unlock warning switch circuit)
Other materials:
Wiring diagram
1 Inspect terminal voltage(pi)
(a) turn
Turn the ignition switch to on.
measure voltage between terminal 5 (pi) of cruise control
ecu assy and body ground, when the cruise control main
switch button is on and off.
Ok:
2 Inspect combination meter assy
3 Check harn ...
Side mudguard sub–assy lh
Replacement
Hint:
use the same procedures for the rh side and lh side.
1. Remove side mudguard sub–assy lh
Using a clip remover, remove the 8 retainers and 9 clips.
using a moulding remover, remove the mudguard.
2. Install side mudguard sub–assy lh
Install the mudgu ...
Circuit description
1 Check p squib circuit(airbag sensor assy center – instrument
panel passenger airbag assy)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the instrument panel ...