Toyota Corolla (E120): Park/neutral position switch circuit

Share this page:

Other materials:

Inspection procedure
1 Input signal check See input signal check on page 05–745. check the indicator light operation when each of the set/ coast, resume/accel and cancel is turned on. Ok: set/coast, resume/accel switch: the signals shown in the table on the left should be output when each switch is ...

Follow the correction procedures. (vehicles with a smart key system and with a drive monitor display)
After taking the specified steps to correct the suspected problem, check that the warning light turns off. ■SRS warning light This warning light system monitors the airbag sensor assembly, front impact sensors, side impact sensors (front door), side impact sensors (front), side impac ...

Replacement
Hint: components: 1. Precaution 2. Disconnect battery negative terminal 3. Remove front door scuff plate rh 4. Remove rear door scuff plate rh 5. Remove front door opening trim rh 6. Remove rear door opening trim rh 7. Remove lap belt outer anchor cover 8. Remove center pillar garnis ...