Toyota Corolla (E120): Oxygen sensor

Dtc p0130 oxygen sensor circuit malfunction (bank 1 sensor 1)

Dtc p2195 oxygen sensor signal stuck lean (bank 1 sensor 1)

Dtc p2196 oxygen sensor signal stuck rich (bank 1 sensor 1)

Share this page:

Other materials:

Replacement
Hint: installation is according to the reverse order of the removal. 1. Remove rear door weatherstrip rh 2. Remove rear door weatherstrip lh 3. Remove rear seat cushion assy (, 72–8) 4. Remove rear seat back assy (fixed type rear seat) 5. Remove separate type rear seat back assy (separate ...

Thermostat
Replacement 1. Remove engine under cover rh 2. Drain coolant 3. Remove fan and generator v belt 4. Remove generator assy Disconnect the wire clamp from the wire clip on the rectifire end frame.  remove the rubber cap and nut, and disconnect the alternator wire.  d ...

Inspection procedure
1 Check p squib circuit(airbag sensor assy center – instrument panel passenger airbag assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the instrument panel ...