Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Readiness monitor drive pattern / Oxygen / af sensor heater monitor
Toyota Corolla (E120): Oxygen / af sensor heater monitor
- Preconditions
The monitor will not run unless:
- mil is off
- drive pattern
- connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.
- Start the engine and allow it to idle for 9 minutes.
- Drive the vehicle at 25 mph (40 km/h) or more for at least 2 minutes.
- If the readiness status dose not switch to complete, make sure that the preconditions are met and the ignition switch turned off and then repeat steps (2) and (3).
Other materials:
Brake fluid
■ Checking fluid level
The brake fluid level should be between the “MAX” and “MIN” lines on the tank.
■ Adding fluid
Make sure to check the fluid type and prepare the necessary item.
1 Slide and lift up the rubber strip to partially remove it as shown.
2 Disconnect the ...
Center stop lamp assy
Replacement
1. Remove package tray trim panel assy (w/o rear spoiler)
2. Remove center stop lamp assy (w/o rear
spoiler)
Remove the center stop light assy as shown in the illustlation.
3. Remove center stop lamp assy (w/ rear
spoiler)
Remove the 2 screws.
disconnect th ...
Unlocking and locking the doors from the outside
◆ Smart key system (if equipped)
Carry the electronic key to enable this function.
1 Grip the driver’s door handle to unlock the door. Grip the passenger’s door
handle to unlock all the doors.* Make sure to touch the sensor on the back of the
handle.
The doors cannot be unlocked for ...