Toyota Corolla (E120): Overhaul
Hint
: components:
1. Remove rear wheel
2. Remove spare wheel cover assy
3. Remove rear floor finish plate
4. Remove luggage compartment trim cover inner lh
5. Remove rear shock absorber with coil spring
- Support the rear axle beam with jack.
- Remove the 2 nuts and bolt.
- Remove the nut, washer and shock absorber.
6. Remove shock absorber assy rear lh
- Using sst, compress the coil spring.
Sst 09727–30021
Notice
: do not use an impact wrench. It will damage the sst.
- Using a 6 mm hexagon wrench to hold the piston rod, remove the nut.
- remove the support plate, cushion, spring bracket, upper insulator, suspension support, spring bumper and coil spring.
7. Inspect shock absorber assy rear lh
- Compress and extend the shock absorber rod and check that there is no abnormal resistance or unusual sound during operation.
If there is any abnormality, replace the shock absorber with a new one.
Notice
: when disposing the shock absorber, see disposal on page 27–7.
8. Install shock absorber assy rear lh
- Using sst, compress the coil spring.
Sst 09727–30021
Notice
: do not use an impact wrench. It will damage the sst.
- Insert the coil spring to the shock absorber.
Hint
: fit the lower end of the coil spring into the gap of the spring lower seat.
- install the spring bumper and suspension support.
- set the upper insulator to the spring bracket.
- Position the spring bracket with upper insulator as shown
in the illustration.
Hint
: place the rh side on the symmetric position to the illustration.
- install the cushion and support plate.
- temporarily tighten a new center nut.
- remove the sst.
Sst 09727–30021
- recheck the direction of the spring bracket.
- Using a 6 mm hexagon wrench to hold the piston rod,
tighten a new nut.
Torque: 56 n·m (571 kgf·cm, 41 ft·lbf)
9. Install rear shock absorber with coil spring
- Install the shock absorber, temporary tighten the nut and washer.
- Install the 2 nuts and bolt.
Torque: 80 nvm (816 Kgf·cm, 59 ft·lbf)
10. Stabilize suspension
- install the rear wheel and jack down the vehicle.
Torque: 103 nvm (1,050 Kgf·cm, 76 ft·lbf)
- bounce the vehicle up and down several times to stabilize the suspension.
11. Fully tighten rear shock absorber with coil spring
- Fully tighten the nut.
Torque: 80 nvm (816 Kgf·cm, 59 ft·lbf)
12. Inspect rear wheel alignment
Other materials:
Taking out the spare tire
1 Remove the luggage floor cover.
2 Remove the tool tray.
3 Loosen the center fastener that secures the spare tire.
CAUTION
■When storing the spare tire
Be careful not to catch fingers or other body parts between the spare tire and
the body of the vehicle. ...
If the vehicle battery is discharged
The following procedures may be used to start the engine if the vehicle’s
battery is discharged.
You can also call your Toyota dealer or a qualified repair shop.
If you have a set of jumper (or booster) cables and a second vehicle with a 12-volt
battery, you can jump start your vehicle by fo ...
Temporarily engaged gear steps selection mode in the D position
To drive in temporary gear steps selection mode, operate the “-” and “+” paddle
shift switches. The gear steps can then be selected by operating the “-” and “+”
paddle shift switches. By selecting gear step using paddle shift switches, you can
control engine braking forces.
1 ...