Toyota Corolla (E170): Outside temperature display

The temperature display shows temperatures within the range of -40°F (-40°C) to 122°F (50°C).

► Type A

► Type B

► Type B

► Type C

► Type C

► Type D

► Type D

■The outside temperature is displayed when

■The outside temperature is displayed when

►Vehicles without a smart key system The engine switch is in the “ON” position.

►Vehicles with a smart key system The engine switch is in IGNITION ON mode.

■Display

In the following situations, the correct outside temperature may not be displayed, or the display may take longer than normal to change.

●When the vehicle is stopped, or moving at low speeds (less than 9 mph [15 km/h]).

●When the outside temperature has changed suddenly (at the entrance/exit of a garage, tunnel, etc.) ■When “--°F” is displayed

The system may be malfunctioning. Take your vehicle to your Toyota dealer.

    Share this page:

    Other materials:

    Inspection procedure
    1 Input signal check See input signal check on page 05–745. check the indicator light operation when each of the set/ coast, resume/accel and cancel is turned on. Ok: set/coast, resume/accel switch: the signals shown in the table on the left should be output when each switch is ...

    Replacement
    1. Remove front door scuff plate rh Using a screwdriver, remove the front door scuff plate rh. Hint: tape the screwdriver tip before use. Remove front door scuff plate lh Remove rear door scuff plate rh Using a screwdriver, remove the rear door scuff plate rh. Hint: tap ...

    Inspection procedure
    1 Inspect fuse(stop) Turn the ignition switch to off.  remove the stop fuse from the instrument panel j/b.  check continuity of the stop fuse. Ok: continuity 2 Inspect stop lamp switch assy Disconnect the stop lamp switch assy connector. check continuity betw ...