Toyota Corolla (E120): Output shaft assy (c59)

Share this page:

Other materials:

Inspection procedure
1 Check relay (marking: starter cut) Inspect the relay continuity, as shown in the illustration and table. Standard: 2 Check tvip ecu Disconnect the tvip ecu connector.  turn the ignition switch position to the start.  measure the voltage between the termina ...

Hydraulic test
1. Perform hydraulic test Measure the line pressure. Notice: Do the test at normal operation atf temperature 50 to 80 °c (122 to 176 °f). The line pressure test should always be carried out in pairs. One technician should observe the conditions of wheels or wheel stopper outsi ...

Overhaul
1. Remove repair service starter kit Remove the nut, then disconnect the lead wire from terminal c. Remove the 2 screws which are used to secure the repair service starter kit to the starter drive housing.  remove the repair service starter kit.  remove the return ...